We will try the K-Box DJ-Rambo Man Blocks:
Very stylish exclusive box:
Pin package with special parts.
The instructions are packaged separately; there are a total of three stickers, all of which are transparent stickers.
The first package starts:
The number of parts in a single package is comfortable enough to control, with some challenges, but the overall number is acceptable.
Obviously this is the part of the mech torso, the mech starts with the torso is a more sensible step, you can see the main arm and leg joints are all large inner ring teeth to carry, this mech is not a small scale.
Open the second package:The parts are almost entirely technological.
This step will be slowed down because some steps need to be carefully looked at to avoid missing steps.
Package 3: A lot of granular pieces start to appear.
It turns out that when you complete the head assembly, no wonder so many small particles of parts.
The details of the head are extremely restored.
The silver parts on the arms are roll-painted with metallic paint.
Package 4:
Thick arm idle head so small, arm elbow wrist knuckle finger joints are movable.
The upper half of the body is completed, if there is a bracket would be good, you can hang up.
Fifth package Parts:
Sixth package:Finish the other leg, ankle, knee, hip are movable.
Pack 7:
Pack eight, this time two packs started at the same time, the end is easier
Easy to complete, feel the foot part of the detail is less some.
All done:
The whole breastplate part is very full.
The arm swing doesn't interfere with the front part.
With the addition of stickers, the facial details are richer, the head can be turned 360 degrees, and the head can be raised up and down, but it is difficult to support.
These two spring-like parts of the waist are easy to fall off.
The finger joints are the most flexible:
The arm can rotate the whole arm.
The hip joint was supported by bispherical joint with cross shaft locking in addition to internal and external teeth.
The arms are very thick, and the body only has two tires, which doesn't seem very reasonable.
The structural support of the foot arch will do, but it looks a little empty.
It would be even better if we could arrange a wheel in the ankle.
The structure of the two wings on the back is easy to fall off and can not be stressed there, so it is not recommended to lie flat for storage, even if you want to lie down you can take the wings off separately.
These two blue gears on the back can adjust the lumbar posture, but also can use this function to adjust the center of gravity.
The standing center of gravity is slightly forward, and if the joints are square, the upper body weight is very heavy, and the whole will have a forward leaning situation, then it is necessary to use the waist gear to adjust to achieve more movement.
Finally invited the two anti-Hulk brothers to see, more reflective of this huge.
Thanks for your visiting! If you are interested in that,can get Here available!
